tghs

6. make long reach small rivet tool.. (stack and boiler shell work)

1..duplex feed pump.. block needs steam ports drilled, 3 main sections soldered as 1, pistons and shafts need to be made..
2.. boiler, boiler shell and burner unit,, plans drawn up,, almost all materials in hand,, several PM valve kits and pipe fitting sets waiting in boxes..
3. complete servo powered engineman..
4.. water tanks and hotwell tank..

just about complete,, a little clean-up,, maybe a few washers on the pivot pins.. trim down and give the hardwood board a routed edge and some finish.. maybe some colored heat-shrink on the handle. fun little kit,, good way to back on the machines.

Not my work, it came that way!!!nice kit..

a little lathe time today,, all that's left to do is the lever and linkages..