Jason,
Do you think they wouldn’t form well or be out of place slightly?
Thanks
Mark
gadabout
Full Member · Joined Jan 2013 · Last active 1d ago
Full MemberMember
About
- This member hasn't added anything here yet.
Recent posts
All posts- In topic · 2 Jul
- In topic · 2 JulJason,
Would you print it with the drilled holes in place ( undersize) but not threaded ?
Thanks
Mark - In topic · 2 JulJason, thanks
The ALSiMg works out at 84$ the 6061 at 135$, wondered if it was worth the extra cost
Mark - In topic · 2 JulHi,
I’m thinking to get an engine block 3d printed, say a Seal block, what alloy would be good to get it done in ? 6061 or the ALSiMg ?
Thanks
Mark - In topic · 2 JunAdev, thank you!
Mark