JBM3M

I got a regulator that I can adjust down to as low as 1 lb, unknown accuracy, but it is minimal.  Still need to get it tried.  Trying to get ready for a snowbird trip down south for a few weeks and avoid some of the predicted cold weather.  Have not tried with demand valve as the pressure is too high and it opens the valve a bit. Yes I was trying to do it straight and all I got was a few pops early on.  Will try that candle thing, good idea.

So I have been all over the internet trying to get a basic jet size for the propane fuel system and at what steady pressure?  I am getting a couple pops and that is it.  Firing either cylinder at TDC.  Do not have a purge valve, just single exhaust each cylinder.  Compression is noticed, unknown value.  I do seem to get a purge out on the intake side of things in addition to the exhaust purge out.  At this point guessing on "jet" size. Thanks

I could add counter weights to the crankshaft, machine up a couple out of lead if need be.  Got a ways to go to worry about that.

Had Wifey pick up some at WinCo and it took 2 days but it got it out.  I am one happy camper.

soaking now, not sure of chemical composition